I have recently created a Map of routers and switches for a client, I’m not a network professional so I basically just created a filter for “all ‘Network.Router’ or ‘Network.Firewall’ and it is showing me a map of all of the L3 connections.
I think it looks good but my issue is every time I click “save” or close and re-open the map, it resets the positions of all of the nodes so I have to drag them out again. Is there any way to make the node locations permanant?
Best answer by TonyAndres
Hello Jeff,
In the map you want to change, click on the gear icon on the upper right-hand side and click the Design option. Then, click on the Map icon (the icon that looks like 4 circles in a cross pattern) and enable the option for Fixed Current Nodes in Place. Now when you move the nodes around and click the Save button, the placement of the nodes will be saved.
Regards,
Antonio Andres
Principal Technical Support Engineer | ScienceLogic
Hello Jeff,
In the map you want to change, click on the gear icon on the upper right-hand side and click the Design option. Then, click on the Map icon (the icon that looks like 4 circles in a cross pattern) and enable the option for Fixed Current Nodes in Place. Now when you move the nodes around and click the Save button, the placement of the nodes will be saved.
Regards,
Antonio Andres
Principal Technical Support Engineer | ScienceLogic
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.