Forum Discussion

Samuel's avatar
Samuel
Participant
4 months ago

Cisco Cat9500FixedSwitchStack Alerts

  Cisco: Power Supply problem. Currently, Power Supply (TenGigabitEthernet */*/* Supply Voltage Sensor) status: unavailable Alerts from Cat9500FixedSwitchStack This is something not an usual aler...
event_management
  • TonyAndres's avatar
    TonyAndres
    4 months ago

    Hello Samuel,

    I apologize for the delay in getting you a response. The event shows the event source is Dynamic, which means that the event is being generated by a dynamic application aligned to the device. If the dynamic application was auto aligned, then it means SL1 detected that the SNMP OIDs the application collects were detected on the device so this could be a legitimate issue on the end device. In this case, please work with the system administrator to see resolve the issue.

    If the dynamic app was manually aligned, then it is possible that the dynamic app does not belong on this device, however, if this was the case, then it would be very unlikely that the dynamic app would be collecting data and generating events. Based on the information provided, this does appear to be a legitimate issue on the end device. Please investigate with the system administrator for that device.

    Tony Andres

    Senior Technical Support Engineer | ScienceLogic

Issac's avatar
Issac
Contributor III
4 months ago

Hi ,

I hope you are getting these alerts from Cisco Environment Entity  Dynamic application which will discover your fiber channel connected port for temp/power monitoring  which uses CISCO-ENTITY-SENSOR-MIB.

And there will be one more DA Cisco Environment Status which polls the Actual power and temperature modules and uses CISCO-ENVMON-MIB.